[urq] MC-2 Conversion - Flywheel question

Ado Sigal a.sigal at bluewin.ch
Sun Oct 14 11:12:11 PDT 2007


Visually they might look same, but spacing of the flywheel mounting 
holes is done in sequence, so that would fit in only one position, hence 
the absence of markings or position pin. Repositioning the pin is the 
way to go.

Ado


urq wrote:

>>>>>
>
>Interesting note on the flywheel.  John showed me that if you offset the WX
>flywheel by one mounting bolt hole the pin lines up with the MC flex plate
>pin.  It seems like all we need to do is to make a new TDC mark on the
>flywheel and we're good to go.  Does anyone know if we're missing something?
>>From my look at the holes there does not seem to be any of them which are
>offset from the others.  
>
>>>>>
>
>Steve B
>San José, CA (USA)
>
>
>  
>




More information about the urq mailing list