[urq] Shift linkage pall socket
urq
urq at pacbell.net
Mon Feb 25 11:15:25 PST 2008
Are you talking about the one that the shift rod plugs into at the transmission end or one of the two on that locating rod that goes from the bell housing to the shift linkage? Either way it is a PITA, but they can probably be recreated. I'm pretty sure I have one of the ones that holds the transmission shift rod in place (new) ... it is the same part as on the 5000T. I don't have the other ones ... but I did have that rod pop off the bell housing after I got the car back.
Anyone know anyone who might make replacements/copies?
Steve B
San Jose, CA (USA)
Patrick Carlier <p.carlier at pandora.be> wrote: If all else fails , I've got a few spares .
No longer need them cause I've put in a six speed .
But , I'm in europe . So shipping might be pretty expensive .
Pat
Belgium
----- Original Message -----
From: "Fluhr"
To:
Sent: Monday, February 25, 2008 5:30 PM
Subject: [urq] Shift linkage pall socket
>
> Urq'ers,
>
> The large plastic ball socket that fits in the linkage rod on
> the Urq shifter shaft disintegrated on my car. The dealer
> lists it NLA (which is crazy given the number of 016 cars/trannies
> that use it). Does anyone know of a replacement of any type
> (e.g. OEM or aftermarket)?
>
> Thanks,
> Eric
> '82 urq
More information about the urq
mailing list