[urq] parking lights not working

[Jim Miller]

Thanks! Again! Fixed!
Just wanted to get back and thank everyone about the parking light  
demon part two: the turn signals. This issue turned out to be  
improper connection to the hazard switch blade terminals due to  
corrosion. I pulled the switch out and cleaned up the terminals with  
the Dremel, then snapped it back in. Turn signals are working and  
brighter than before! I will also try Ingo's suggestion to run a  
separate ground to the tail lights by using the male tab on each bulb  
housing to assist with proper grounding. Much appreciated!
Later.
Jim