[urq] Remaking UrQ rocker panels?
Justin Rettaliata
jretal at gmail.com
Thu Feb 17 08:30:46 PST 2011
Hello all,
I'm putting this out as a feeler to see if anyone would be interested.
I'm in the process of putting modified UrQ flares onto my 4000 (they're
fiberglass, take a breath... didn't cut up a good one :) )... I want to use
metal rocker panels to match the fender flares vs fiberglass, and was going
to have a set made up. Unfortunately, the setup cost is prohibitively
expensive to just bang out 2 rockers. Even making up 4 (to use to repair
the damaged rockers on our UrQ) is still overly expensive.
So the question is, would anyone be interested in these if I were to have a
set made up? You can buy them as a single piece (6' long) or two pieces.
They are dimensioned off the portion under the door itself, so won't be an
exact match once it hits the rocker panel fwiw.
I'm not looking to make any $$, just offset the setup costs to have them
bent (on a CAD machine w/ dies, etc).
Please let me know if you're interested! I'm hoping that it'll be less than
$75ish per piece plus shipping, but depends on how many people are
interested. The more people I get confirmed, the less they will cost
essentially I'm good for 4. These will be made from 16-18 ga GALVANIZED
steel. So these won't rust away like the rest of the car... lol.
Thanks all, please let me konw ASAP.
-Justin (jretal on QW, Motorgeek, AW).
More information about the urq
mailing list