[urq] Clutch for Urq with 3b?

[Chris Miller]

I'm in the same boat; 85 urq getting a 3b from a 200q20v.  My initial
searching shows that the non-torsen 016 locker transmission has a different
transmission output spline size than the later torsen 016 like in the
200q20v.  So, can't use the same clutch disk.  I will confirm this when it
stops raining, as I have a disk off the 200q20v.  Also, I believe I read
that the throwout bearing is also different.

Looks like a standard setup for the urq or for an '86-88 5000 turbo is
correct, or performance versions of both.
Are you using the flywheel from the urq or from the 20vt?  I'm hoping to use
the 3b flywheel, and I'm not sure if that is the same as my urq engine is
long gone.

Any suggestions?   Sorry to jump on your thread; are you also using the
engine from a 200q20v, or off an S2?

Chris



-----Original Message-----
From: urq-bounces at audifans.com [mailto:urq-bounces at audifans.com] On Behalf
Of W.Stedman
Sent: Thursday, October 27, 2011 8:33 PM
To: urq at audifans.com
Subject: [urq] Clutch for Urq with 3b?

I have a 1982 Urq and am planning on putting in a 3b 20vt motor and flywheel
in it. And is there a special clutch and pressure plate combo I need to use
with this? 

_______________________________________________
Audifans urq mailing list
Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
http://www.audifans.com/kb/List_information

Pictures/Polls/Database at: http://autos.groups.yahoo.com/group/urquattro/

-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2012.0.1834 / Virus Database: 2092/4578 - Release Date: 10/27/11