[urq] More Weird UrQ Behavior

Sat Sep 7 08:59:06 PDT 2013

Same here , my 7A converted CQ has un unmodified fuel system .
Original tank , inline filter , pump , accumulator .
Only a moderate 190 Hp , but still , no problems with cavitation er similar 
.

What is interesting to know is that there are different fuel tanks .
Theer are teh ones with the 12mm outlet , ususally with the inline filter .
But I've also seen tanks with 8mm outlets and no prefilter .
These just might cause cavitation , I honestly don't know .
But I did change the 8mm tank for a 12mm one just to make sure , and
added the inline filter wich was available at that time .

@Martin
What is tha blue coupling in your fuel pump inlet ?
Something damaged and repaired maybe ?

Pat

----- Original Message ----- 
From: "Martin Pajak" <martin at quattro.ca>
To: "'Qshipq'" <qshipq at aol.com>; <benswann at verizon.net>; "'AF'" 
<afinn1 at gmail.com>
Cc: <urq at audifans.com>; "'Quattro List'" <quattro at audifans.com>
Sent: Saturday, September 07, 2013 4:27 PM
Subject: Re: [urq] More Weird UrQ Behavior

All,

My '84 still have the fuel pressure accumulator, did not stop it from making
336whp and 380 torques.
https://lh5.googleusercontent.com/-U8J-MZG7M4o/Uis3Unb4ZbI/AAAAAAAAIdI/hv_dM
uKqXJo/w807-h605-no/DSC03059.JPG

Hope this helps.
Martin Pajak

http://www.quattro.ca

1981 VW Scirocco, all original
1982 Audi Ur-quattro, SQ project
1983 Audi 80 quattro, Euro 2-Tür
1984 Audi Ur-quattro, 20vt with 6-speed
1993 Audi 90 CS quattro, 2.5 TDI with 6-speed
1993 Audi 80 quattro Avant, 2.5 TDI with 6-speed
1994 Audi S2 Avant, stock

-----Original Message-----
From: urq-bounces at audifans.com [mailto:urq-bounces at audifans.com] On Behalf
Of Qshipq
Sent: 7-Sep-13 08:54
To: benswann at verizon.net; 'AF'
Cc: urq at audifans.com; 'Quattro List'
Subject: Re: [urq] More Weird UrQ Behavior

I flat don't buy the fuel capacitor idea/problem. First before you *fix*
anything - identify the problem. A couple months ago when I was help deskin
a possible fuel problem with a fellow urq owner I had him perform a fuel
test. Specifically, measure the amount of fuel that comes out that fuel
port at the bottom of the tank in 30seconds. IIRC the fuel was something in
the hood of 70gal per hour. That's with an unclogged screen in the tank.

I've also witnessed urq dyno runs over 300atwhp with efi cars with fuel
pressure accumulator still in place. And numbers over 300atwhp with no flux
capacitor installed before the fuel pump. When this topic arose from Ben
several years ago I spent some time helping Dupree develop a capacitor setup
but in the end, as I suspected, that was not the problem. His efi 20vt
conversion was well over 300atwhp in its last dyno run.

First thing to ck and compare is the fuel flow at the port. I suspect that
in tank screen is the cause of most aeration. Because I can't see an engine
exceeding the amount of fuel coming out that port. After that skip the
inline filter. After that, I would measure the amount of fuel coming back
to the tank and do some math.

It's certainly possible there is aeration but that is not a capacitor
problem IME. The math doesn't add up nor does my experience with dyno
numbers with all that 'restrictive' hardware installed.

If the screen is clogged in the tank and you have done no test for that
building a fix is premature IMO/E

Cheeers and my .02

Scott J

Sent from my Samsung EpicT 4G TouchBen Swann <benswann at verizon.net>
wrote:Somewhere I have pictures/plans on making this "fuel capacitor".
I'll see if I can find and post them.

Ben

From: AF [mailto:afinn1 at gmail.com]
Sent: Wednesday, September 04, 2013 10:55 PM
To: Ben Swann
Cc: <urq at audifans.com>; Quattro List
Subject: Re: [urq] More Weird UrQ Behavior

This is a follow up email. After trying everything including a 034efi pump
in surge tank...The issue was crud in the fuel tank. I got a used tank and
cut off the bottom. Cleaned it. Por15'd it. Permanently removed the filter
sock and used a cleanable in line fuel filter. All issues solved.

Andrew Finney

1985 urq

Sent from the road

On Mar 27, 2010, at 7:56 AM, "Ben Swann" <benswann at verizon.net> wrote:

Andrew,

I'll lay 95% odds you are starving the pump. Changing to a bigger badder
pump won't fix the problem. I had this frustration with my EFI converted
'83.

What is happening is the tube coming out of the tank is insufficient to
provide adequate flow to the pump. The fuel delivery on the CIS cars is
designed to have a higher pressure and less flow. When the pressure is
dropped and flow increased for EFI it basically sucks the fuel faster than
the 3/8" bent tube can deliver. The result is cavitation at the delivery
side of the pump. The problem gets worse as the car runs for a while. I
hit on the problem by finding I could clear the problem by reversing
polarity on the pump for a second - this drives the air out of the lines.

There are a variety of permanent fixes ranging in complexity - pre-pumps to
surge tanks, in-tank pumps, modifying the bottom of the tank for a much
larger fitting (welding a gas tank!) and fuel cells replacing original tank,
etc. Look up surge tank and related and you will find this is a common
problem, particularly with drag racing and EFI converted cars.

I toyed with this for over a year - drove me nuts. Many on the list
probably remember my frustration. Pulled the tank multiple times, cleaned
the in tank sock, swapped pumps out - the nice 044 pumps and more expensive
pumps only made the problem worse. I actually had better luck with a
WALLBRO and the OE pump with smaller inlet worked better than the later CIS
pump made for NF/NG!

The pre-pump filter made things worse, and I removed it which helped some,
but the problem persisted. I did a lot of research and much trial and
error.

I did not want to remove the tank unless I absolutely had to. So my fix was
to fabricate what I call the "fuel capacitor". It is simple in concept, but
devil in the details since there is not much room to put something between
the pump and the tank - angles, clearance, kinked lines, etc. It is a 2"
copper confabulation - kind of a 45 Deg. Angle between two 6" pipes making
one angled pipe capped at both ends. The pipe just fits in between the
pump, mounts, brackets and tank. I had to cut out the unused portion of the
difflock cable assembly - already removed and being replaced with pnuematic
actuator. If you need to maintain the cable system then this will be much
harder to implement.

There is one large outlet that sits at the lowest point in the pipe. I
should have added a drain fitting because of the lack of pre-pump filter and
probably need to drain it every now an then - I plan to add one later,
possibly with a fuel water seperator that sits sloghtly lower than the
assembly.

I toyed with a variety of fuel feed and return schemes, but simplicity
prevailed. Both the inlet and return are installed in the "fuel
capacitor". I need to review what I did exactly, but IIRC there is one
large fitting at the utmost top of the tank - nearly jammed into the feed
line with a very short line. It was difficult to get it installed without
kinking, but once done, there is little to go wrong.

For the return IIRC it it actually teed into the surge pipe offset at slight
angle near the top of the pipe. I was not sure if it would work, but makes
sense that it does and in fact adds additional but equalized pressure feed
side to not only keep the pump from cavitating, but also keep the feed line
from the tank clear of debris.

In short it works, plain and simple. The only problem I had was using non
fuel grade line which decided to rupture one day - thank God it was in my
driveway and not on the highway. So use good hardware and plan it out for a
good reliable solution.

If you or any listers want picture of the assembly, LMK and I will send
them. I plan to put this on my site, but these things tend to take low
priority.

HTH.

Ben

[Date: Fri, 26 Mar 2010 12:21:43 -0700
From: AF <afinn1 at gmail.com>
Subject: [urq] More Weird UrQ Behavior
To: urq <urq at audifans.com>
Message-ID:
<ed47d8be1003261221w2a4c5064v1f7af3a500956166 at mail.gmail.com>
Content-Type: text/plain; charset=ISO-8859-1

So, at the past 2 track events I've attended with my V8 UrQ I have had a
weird issue with engine cutout at high rpms, usually in 3rd gear, but on the
straightaways in 4th gear. They seem to occur during any throttle position,
like cresting a hill, or accelerating out of a corner, which is somewhat
unnerving. There are no fault codes thrown at all, which makes me think it's
a fuel supply issue. Here's the weird thing, I would say it a fuel pump
relay issue, but wouldn't the engine stall (that's what my old UrQ and Coupe
GT would do on the highway), but in this case there's no power until I
depress the clutch after slowing a little and downshifting, then the power
is all back. The engine never stalls and shuts off! I confirmed it's not a
rev limiter issue by redlining with moderate throttle input and no issues
occured. It's definitely at higher RPM though. Does anyone have a thought? I
thought about relaying the fuel pump, but wouldn't the engine simply stall
with no fuel supply, or will it simply keep running with the car in motion
and clutch out without shutting down or turning on all the warning lights on
the dash?

Any help is appreciated. Thanks.

Andrew Finney
1985 UrQ 4.2L ABZ]

_______________________________________________
Audifans urq mailing list
Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
http://www.audifans.com/kb/List_information

Pictures/Polls/Database at: http://autos.groups.yahoo.com/group/urquattro/

_______________________________________________
Audifans urq mailing list
Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
http://www.audifans.com/kb/List_information

Pictures/Polls/Database at: http://autos.groups.yahoo.com/group/urquattro/

-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2013.0.3392 / Virus Database: 3222/6644 - Release Date: 09/06/13

_______________________________________________
Audifans urq mailing list
Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
http://www.audifans.com/kb/List_information

Pictures/Polls/Database at: http://autos.groups.yahoo.com/group/urquattro/