[V6-12v] Skew Auxiliary Belt Tension Pulley ( 12v v6)

Johan Voges johan.voges at somchem.co.za
Wed Oct 20 10:24:21 EDT 2004




  Good Day Gentlemen

  Is it normal for the Auxiliary Belt Tension Pulley to go out of alignment.

  It is causing the belt to run against the tension bracket.

  Here in South Africa the agents charges R1500 ($250) for it and says
pulley and bracket is a unit.

  Can just the pulley bearing be fixed.

  Thank You very much for a excellent forum. Words cannot discribe.

  Regards

  Johan Voges

  1994 Audi 500SEL ( 100 V6 )
  1989 Audi Turbo  ( 200 )
  1987 Audi 400    ( 200 with 1800 Golf engine )




Notice: The information contained in this e-mail may include 
confidential, proprietary and/or legally privileged information 
intended for the sole use of the addressee. If you have received 
this message in error, please notify the sender immediately by 
return e-mail and delete it from your system. Unless otherwise 
stated this e-mail or any part thereof may not be used by any 
party other than the addressee and then only for the purpose 
intended by the sender. 
Somchem does not represent and/or warrant that the integrity of 
this communication has been maintained nor that the 
communication is free of errors, viruses, interception or 
interference. Somchem reserves the right to monitor all e-mail 
communications through our networks. Any views expressed in 
this e-mail are those of the individual sender unless stated 
otherwise by our duly authorised representative whose 
identification has been verified.





More information about the V6-12v mailing list