[V6-12v] ABS

[Chris Thorp]

Clive Young wrote:

>I had a similar problem during the summer. I put a voltmeter set to AC on
>each of the sensor inputs going to the ABS module under the rear seat,. 3
>out of the four sensors gave readings of 100 - 400mv. One gave 0. Checked it
>and the sensor was hanging out. Point is try putting the meter on all 4 , it
>may tell you where your problem lies. I know that ring has to be perfect all
>the way around and maintain the same distance from the sensor . Maybe one
>isn't in right ? just a suggestion...
>  
>
Also, if you're doing this, you need to get a set of "ablative caps" for 
the ABS sensor pickups.  These are small plastic caps that fit over the 
tip of the pickup.  You put the cap on, install the sensor with the cap 
touching the rotor, and that's it.  Can be done without, but for the 
price of the caps you'll save a lot of hassle.

-Chris