[V6-12v] Motor wont start G28 Andrew Muff

[Doug Macy]

I am having similar troubles with a 94CSQ AAH V6 2.8l - car was rescued, new
clutch, flywheel, slave & master  installed, got it running "perfect" for
3-4 weeks then one day it refused to start. have swapped out coil pack POS,
cam, crank, speed sensors, checked all fuses, fuel pump cycling and fuel at
FPR on the rail..

 

"Update: no ignition. Volt meter shows power to the injectors but no pulse.
An open spark plug hole confirms no fuel either. Seems like the ECU doesn't
want this engine to start. But still no codes. Ideas?

 

On Jan 3, 2013, at 1:04 PM, "Andrew Muff" <andrew at muffster.com> wrote:"

 

> Argh! Ok, red herring. After a day and a half of tracing down this speed
sensor, turns out that's not it. Turns out the speed sensor is a white plug
and 1 of the 2 plug wires from the ignition coil is a white plug. They were
reversed. 

> 

> But problem not solved. Now ECU throws no codes. And engine won't start.
Just tested for spark and both #1 and #4 cyl are dead, so the whole ignition
coil has no power. I've traced back the wires and confirmed these are
plugged into the right harness by confirming wire colors with the schematic.


> 

<<Clipped>>

 

Doug Macy

Cumberland, MD 21502

1994 90CSQ "Freeda" the gift horse