[V8] V8 rear diff measurements and V8q for sale

[Alan Kramer]

On the rear diff, does anyone know the exact offset in mm of the centerline 
of the pinion shaft with the center of the ring gear?  Bentley doesn't 
appear to discuss the inside of the rear diff in any detail...and I'd like 
to know that to see if I can mix and match some parts to swap to a 4.11 FD 
from 4.9 while I'm adding the torsen to my CGT tranny.

Also, I'm putting my '90 V8q up for sale.  $4500 drives it away.  180k 
miles, new steering rack (less than 1 mile on it) new heater core, 6k miles 
on T-belt, cold R12 AC, sport seats, platinum inside, lago blue outside, 
Dunlop Graspic snows with less than 2k miles, no hydraulic leaks, new 
battery (1 month old), 6 disc changer in trunk, non-bose system.  New front 
rotors & pads with Hawk HP+ pads (under 250 miles) G60's, not UFO.  Spare 
transmission from parts car available for $500 extra.  Everything works but 
drivers side seat heater.  Recent fool pump and flywheel sensors.  No rust.  
Comes with paper & CD Bentley, paper & CD wiring diagrams, and misc. other 
technical literature, all receipts from last 80k miles.  Has been my daily 
driver for past 3 yrs.  Just bought new MB CLK320 and have too many cars 
now.  Located near Baltimore, MD.  Will take pics, this weekend.

Alan
-----------------------------------
Alan Kramer
http://www.geocities.com/audikramer

'83 UrQ V8
'83 CGT 20vt
'86 4kcsq
'90 V8q

-----------------------------------

_________________________________________________________________
Get ready for school! Find articles, homework help and more in the Back to 
School Guide! http://special.msn.com/network/04backtoschool.armx