SV: [V8] stupid question - cutting a V8 in half

[Jorgen Karlsson]

Hi,

The passenger side head is very close. You will have to redrill the intake
bolt pattern using a VW 16V intake gasket. It looks like I will use 16v
gaskets and bolt pattern for my custom intake. I don't know about the
exhaust bolt pattern. The cams can't be used at all, you need cam's from a
four pot.

The driver side head can probably be used too with some tricks.

Jorgen

> -----Ursprungligt meddelande-----
> Fran: v8-bounces at audifans.com [mailto:v8-bounces at audifans.com]For Jeremy
> Ward
> Skickat: den 12 januari 2004 18:39
> Till: v8 at audifans.com
> Amne: [V8] stupid question - cutting a V8 in half
>
>
> Would a 4 valve/cylinder head from a 3.6 fit on a 1.8 VW/Audi motor?  If
> in the off chance that it did bolt up to the block, I assume that it
> would require custom intake and exhaust manifolds, right? (That is,
> nothing from the factory parts bins?)
>
> Any thoughts (other than stop inhaling Toluene)?
>
> - Jeremy
> _______________________________________________
> V8 mailing list
> V8 at audifans.com
> http://www.audifans.com/mailman/listinfo/v8
>