[V8] CV Boot Installer

[Buchholz, Steven]

... that is indeed what it looks like what it was intended to do!  Too bad
the site doesn't give any details about what the maximum diameter is!  I've
got to say that I'm more than a bit skeptical about whether or not an Audi
CV Boot would be able to hold up to the strain ... but what do I know, I'm
still skeptical about the childbirth process too!  :-)  I'm sure you'd need
to install some sort of clamp on the small end where it sits on the half
shaft ...

Steve B
San Jose, CA (USA)
> 
> Anyone seen this tool in action?  Looks to me like it opens up the
> smaller axle boot hole so that it fits over the joint end?  
> If this thing actually works it's going on my "to buy" list.
> 
http://www.thetoolwarehouse.net/shop/AP-7831.html