[V8] WOT

[DasWolfen at aol.com]

In a message dated 11/5/04 8:40:16 PM Eastern Standard Time, 
tonyandlillie1 at earthlink.net writes:

> Take off the 4 bolts that hold the upper part of the front manifold (the 
> part that the ISV bolts to) out, and the top should come off. Then, you can see 
> the throttle plates. They bolt to the manifold somehow obvious, I just can't 
> remember right now. Then you just have to figure out what is holding it 
> open.
> 

6 bolts hold that intake elbow on. Two 4mm allan screws hold the throttle 
plate assembly to the intake.

 I seriously suggest taking the entire linkage apart for cleaning and lube. 
4.2 cars especially are as likely to bind in the throttle plate assembly itself 
as they are to bind in the support bushing in the rear of the linkage.