[V8] Front axle removal ?????

[dsaad at icehouse.net]

This is a good point to stress here kids. It is a good idea to make sure the
bolt head is good and clean so the tool seats fully.
This of course applies to all torx,allen,spline type bolt heads.
And I am not sure if the manual spells this out in plain english but these bolt
heads are "tripple square" - not torx. The special tool was about $5 and if I
remember, it was a 10mm tripple square and fit inside a 10mm socket.

The suck factor is high if you strip out a bolt head here.

Dave

Quoting cobram at juno.com:

>  As with all
> such allen bolts, hammer in the socket to make sure it's bottomed out on
> the bolt before loosening.  There are plenty of  write ups in the
> archives, basically all the same for the type 44's.
>
>
>
> BCNU,
> http://www.geocities.com/cobramsri/
> _______________________________________________