[V8] Heater Box Woes

[Klein, Nathan P]

I've got the four-volume manual and it makes it look so easy.

Whereabout are these screws that I need a long screwdriver to get at?
Are they inside the case?  I don't recall seeing anything of the
sort....but it was mighty hot that day....

-----Original Message-----
From: v8-bounces at audifans.com [mailto:v8-bounces at audifans.com] On Behalf
Of dsaad at icehouse.net
Sent: Tuesday, October 04, 2005 9:16 AM
To: V8 at audifans.com
Subject: Re: [V8] Heater Box Woes

There are a lot of clips - some are pretty well hidden

There are three (I think) screws that take a very long phillips
screwdriver to get out. Mark which side the screws go in - it is not
that obvious two days later...

Remove the heater flap motor (under the white cover) and remove an "E"
clip from one of the flap shafts.

That is all I can remember.

The Bently for any type 44 should cover this in good detail.
It should always be your primary source. I find that the manual usually
covers this stuff pretty well.

Dave