[V8] Speed Bleeders- SB7100

[Scott Phillips]

Listers...

 

After having a wonderful weather weekend for this late in the year (at
least for the Northeast), I had a chance to install the SB7100 (all 4
corners are this number) Speed Bleeders into the Calipers on the V8
(UFO's & Rears). The new bleeders are a bit longer then the originals
(5mm) but went in and work exactly as described. I was able to attach a
hose to the nipple and into a clear container, watch (at least on the
driver's side) as I pumped the pedal until I finally got clean fluid,
closed off the bleeder and had a nice firm pedal. That flushed the fluid
in about 45 min, and that included getting the old bleeders out,. The
rear's weren't too bad as I just replaced the calipers a few weeks ago,
but the front were a bit tougher.

 

I followed the bleeding pattern from the manual RR, LR, RF, LF, RR. I
just wanted to close the loop on the brake bleeding thread from a few
weeks ago. 

 

Scott 

 

Scott Phillips - Director Information Technology and Information
Services
International Process Plants 
17A Marlen Drive * Hamilton, NJ 08691 * USA
Tel: (609) 586-8004 * Fax: (609) 586-0002 * 
email: scottp at ippe.com <mailto:scottp at ippe.com>       Website:
www.ippe.com <http://www.ippe.com/>  

Global Suppliers of Quality Used Process Plants and Equipment
Let us know what plants and equipment you have for sale

________________________________________________________________________
________________________________________________________________________
_________________________

This e-mail may contain confidential and/or privileged information. If
you are not the intended recipient or the person responsible for
delivering to the intended recipient, please be advised that it has been
sent in error and therefore any use is strictly prohibited. If you are
not the intended recipient, or if you are concerned about the content of
this e-mail, please notify us at (609) 586-8004.