[V8] crank removal

[Tony and Lillie]

No reason not too. Just as long as they keep the top/bottom straight, and 
keep them straight for each cylinder, you should be good to go. I personally 
use a piece of foam for this.

Tony Hoffman

----- Original Message ----- 
From: "d saad" <dsaad at icehouse.net>
To: <v8 at audifans.com>
Sent: Wednesday, April 18, 2007 11:34 AM
Subject: [V8] crank removal


>
>
> The machine shop is still looking at my motor, but they say they want to
> remove the crank for honing if needed. Is there any reason not to do this?
> I was hoping to not disturb the bearings but if it is OK - then I will go
> for it.
>
> Any idea about bolt torques if I do take it out?
>
> Dave
>