[V8] wheel bearings

[d saad]

That is a pretty expensive tool that you will probably only use once.
To remove the axle, I think you also have  remove the tie rod to
swing the strut out far enough.
At this point, you are three nuts
away from removing the whole strut - why not just do that and have a
machine shop press in the bearings? That is what I did and as I recall, it
was pretty cheap. Bearings, labor, and an alignment were all under $300 -
and I replaced the upper bearing too. 

Dave
>
http://www.thetoolwarehouse.net/shop/OLD-7325.html
> 
>
tlastre01 at sprintpcs.com wrote:  What is a hubshark and where do I get
one?
> _______________________________________________
>
Audifans V8 mailing list
> Send posts to:
mailto:V8 at audifans.com
> Manage your list connection:
http://www.audifans.com/mailman/listinfo/v8
> Have an Audi V8
question?  Check the Audifans Knowledgebase!
>
http://www.audifans.com/twiki/bin/view/Audi/V8
> Have a V8 answer?
... Please help others by adding to the KB ... all
> contributions
welcome!
>