[V8] Hub Shark Users

[John S. Lagnese]

It most likely leaves space for the whole apparatus. My hub kit needed room 
on the inside of the hub.
----- Original Message ----- 
From: <kneale at knitknacks.com>
To: "20valveList" <200q20v at audifans.com>
Cc: "V8List" <v8 at audifans.com>
Sent: Monday, October 27, 2008 6:31 PM
Subject: Hub Shark Users


> I'm preparing for my first use of a Hub Shark to replace a wheel bearing
> on my 200q20vA.  I've removed the UFO caliper and the axle.  The Hub Shark
> directions say to disconnect the lower control arm, but I presume that's
> to make it possible to swing the bearing housing away from the axle so you
> don't have to pull the axle.  Since I've already pulled the axle, is there
> any reason to also disconnect the lower control arm?
>
>
> _______________________________________________
> 200q20v mailing list http://www.audifans.com/mailman/listinfo/200q20v
>
> _______________________________________
> No viruses found in this incoming message
> Scanned by iolo AntiVirus 1.5.4.5
> http://www.iolo.com
> 


_______________________________________
No viruses found in this outgoing message
Scanned by iolo AntiVirus 1.5.4.5
http://www.iolo.com