[V8] Hub Shark Adventure Story

[kneale at knitknacks.com]

I got my 200q20v's wheel bearing out and back in and then foolishly
pressed in the hub without backing the center of the bearing=one ruint
bearing.  Next one went in a little less hapily, but I also got the hub
pressed back in without destroying the binding.   Just a $40 lesson, I
guess.  Anyway, anybody know how big a gap there should be between the hub
and the bearing housing?  I have about a 4mm gap.  I didn't measure
before, the bearing is against its shoulder and the hub end is at the
inner bearing surface, but the gap just looks larger to me.

Thanks to all who helped.