[V8] Distributor rotor replacing

[Dave Saad]

I will triple it!!

Remove the distributors and then I just use a vise to squish off the  
old rotor. I would not hit the shaft with a hammer because you can  
easily damage it.
Also, be very careful with the cam drive flange. One of them is made  
of some fiber type stuff and breaks easily.
You will also make your life a little easier if you set the motor to  
TDC so you have timing marks for reassembly.

Dave


On Jan 25, 2009, at 8:17 AM, Ron Wainwright wrote:

> I absolutley agree with Ed! It takes 5 minutes to remove the dizzy's.
> I use a 1/4" 8mm socket/ratchet setup with a small extension to  
> remove the cap bolts. &
> a 10mm 1/4" setup to remove the dizzy's.
>
>