[V8] power steering hose

[Ed Kellock]

That's a tricky one.  The first thing you do is get the intake plumbing out
of the way, including the lower portion of the box on the back on the
engine.  I had intended to remove the driver's side distributor but didn't
find that I needed to once I got in there.

Once you get some room to work, it is possible to get a wrench on the bolt.
I used a box-end wrench, if I recall correctly.  Getting the banjo bolt
started back in took some patience.  I used some string wrapped around it a
couple times and through a large straw so I could pull and rotate the bolt
since I couldn't get my fingers down in there.

It's definitely a challenge, but not an impossible one.

Ed
 


-----Original Message-----
From: v8-bounces at audifans.com [mailto:v8-bounces at audifans.com] On Behalf Of
Sean cole
Sent: Monday, June 07, 2010 7:38 PM
To: v8 at audifans.com
Subject: [V8] power steering hose


Hi,

It's been a while since i posted up on here.  I need some help ASAP.  I'm
working on replacing the high pressure feed line from the power steering
pump to the rack.  I can't figure out how in the world you can get the bolt
out of the rack.

Any help would be awesome.

Sean
_______________________________________________
Audifans V8 mailing list
Send posts to: mailto:V8 at audifans.com
Manage your list connection: http://www.audifans.com/mailman/listinfo/v8

You can help keep the audifans site running by shopping at
http://audifans.com/shop/

No virus found in this incoming message.
Checked by AVG - www.avg.com 
Version: 9.0.829 / Virus Database: 271.1.1/2922 - Release Date: 06/07/10
12:35:00