[Vwdiesel] Simple little TDI question Phase II

[Lee Hillsgrove]

>
>Bentley says the O ring under the plastic gizmo is a PITN and MUST be
>replaced every time you take it out.
>
>Buy a half-dozen at a plumbimg shop (cheap there) and keep in the glove
>compartment along with the spare glow plug fuses.
>




  If possible, get a Viton o-ring. It will cost a few pennies more, but
should not swell or dissolve in the presence of biodiesel or additives.
 Metric o-rings are described using OD, ID, and cross section. If you can
get measurements off of the old o-ring, you could bring them to an
industrial supply place or wherever. Standard ones use a dash system of
numbering. Since this should be metric, I won't go into that.  :-))

  Lee
  Oo-v-oO
  PP-ASEL
  KB1GNI