[Vwdiesel] 1.6l 11mm vs 12mm heads

Will Taygan william at taygan.com
Fri Mar 5 10:07:30 EST 2004


What is this bushing, and where does it fit?  I'm pretty sure I have a 1.5
block I'll check again to be sure (1980 with 11mm bolts). It's the
remanufactured head I'm trying to figure out.  On a 1.5 if I look at the oil
return hole, will it be the same size as the oil sending hole?  On a 1.6 the
front (center?) oil return hole is larger than the oil sending hole?  The
return on the head has an extra chunk cut out of it that doesn't match to
the block (block hole is round), but it matches the 4-notch gasket.

Thanks,

Will Taygan
Concrete, WA

----- Original Message -----
From: <LBaird119 at aol.com>
To: <vwdiesel at vwfans.com>
Sent: Thursday, March 04, 2004 10:29 PM
Subject: Re: [Vwdiesel] 1.6l 11mm vs 12mm heads


> First decide which engine block it has.  That'll tell you which
> displacement.
> It'll either be a 1.6, (CR) or a 1.5 (CK).  All 1.6 have the larger oil
> return
> hole (front).  12mm bolts won't fit through the holes in a CR's head.
> They can be reamed if necessary.  The reverse works, the holes are just
> a bit sloppy.  The mentioned bushing lets a 1.5 head be used on a
> 1.6.
>      Loren
> _______________________________________________
> Vwdiesel mailing list
> Vwdiesel at vwfans.com
> http://www.audifans.com/mailman/listinfo/vwdiesel
>




More information about the Vwdiesel mailing list