[Vwdiesel] Any good machine shops in the Puget sound areaSeattle/Tacoma ...
Cotter
cotter at mhtc.net
Fri Feb 17 12:00:34 EST 2006
And do not forget that the pistons are "cam ground" which means they are not
a perfect circle-they are oval shaped--
I do not recall where to take the measurements. I believe the measurement is
taken perpendicular/parallel to the piston pin. ( say that one 5 times real
fast)
I had a VW trained mechanic in the stealership tell me an engine was junk;
until the service manager explained the cam ground piston to him--(warrantee
claim in 1983 as they fumbled around trying to find a noise which ended up
to be a broken flange on the front of the intermediate shaft.)
Good luck
Cotter
-----Original Message-----
From: vwdiesel-bounces at vwfans.com [mailto:vwdiesel-bounces at vwfans.com] On
Behalf Of LBaird119 at aol.com
Sent: Friday, February 17, 2006 1:02 AM
To: vwdiesel at vwfans.com
Subject: Re: [Vwdiesel] Any good machine shops in the Puget sound
areaSeattle/Tacoma ...
Whomever you have do the work, make sure they bore for the
proper piston to cylinder clearance. Most shops want to leave
you with much more than the .001 specified clearance. When
about .0025 clearance is wear limit, you don't want any more
to start than you need!
I had to argue with the shop that did my last one or two. They
wanted to bore it with almost .002 clearance and refused to do
.001 until I showed them in black and white!
Loren
_______________________________________________
Vwdiesel mailing list
Vwdiesel at vwfans.com
http://www.audifans.com/mailman/listinfo/vwdiesel
More information about the Vwdiesel
mailing list