[Vwdiesel] hydraulic head oil pressure

[Finn Rod]

Thanks Guys... stuck in a sender and gauge...

> > From: LBaird119 at aol.com
> To: vwdiesel at vwfans.com
> Date: Mon, 9 Oct 2006 11:30:11 EDT
> Subject: Re: [Vwdiesel] hydraulic head oil pressure
> 
> In a message dated 10/9/2006 8:28:40 AM Pacific
> Daylight Time, 
> dubdeesel at yahoo.com writes:
> 
> > Is there some special reason for this on an
> hydraulic
> > head?? or can I go ahead and put my pressure
> sensor in
> > the normal place in the head... 
> > 
> 
>   Difference is that on the filter housing is right
> after the pump, 
> before the oil goes anywhere else.  On the head it's
> the end of 
> the line so if there's a restriction (or an upside
> down head gasket) 
> you'll know.
>      Loren
> 
> > From: Roger Brown <r.c.brown at ieee.org>
> To: vwdiesel at vwfans.com
> Date: Mon, 09 Oct 2006 08:37:53 -0700
> Subject: Re: [Vwdiesel] hydraulic head oil pressure
> 
 
> 
> On my 1.9D (hyd. head) there was the oil pressure
> switch, for the idiot light, on the 
> head.  I replaced it with a dual output VDO sender
> that has both a switch and an analog 
> sender for a gauge.  Screwed right into the hole and
> the switch drives the dash light just 
> fine.  I have not got the gauge installed yet as I
> need to fab up a panel for it.
> 
> -- 
>     Roger
> 
> 


rod of finland

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com