[Vwdiesel] More Quantum Questions?

mark shepherd mark at shepher.fsnet.co.uk
Wed May 20 07:53:23 PDT 2009


Hurry up Bill, I'm getting bored listening to all this modern Golf talk ;op

----- Original Message ----- 
From: "William J Toensing" <toensing at wildblue.net>
To: <vwdiesel at vwfans.com>
Sent: Friday, May 15, 2009 6:10 AM
Subject: [Vwdiesel] More Quantum Questions?


>
> I did look at my dial gage & it is marked in millimeters I checked it 
> against a metric wrench & it seems to read OK. It is marked 0 to 10 MM & 
> the large dial reads in .01 mm increments. Took the valve cover off again, 
> locked the cam, inserted the IP locking pin, but found there was enough 
> slop in the locking pin that I could move the flywheel about an inch 
> contra clockwise, & bring the flywheel TDC mark which had disappeared, 
> back to TDC, after loosening the cam nut. There also appears a slight 
> amount of slop in the ca lock as the cam gear will move about 1/8 when 
> tightening, if I am not careful. This must be why the Bentley recommends a 
> feeler gage under the cam lock bar, which I haven't done before. Plan to 
> work on the Quantum some more, tomorrow, if wife doesn't hit me with more 
> "honeydos".
> Bill Toensing, Nevada City, CA
> _______________________________________________
> Vwdiesel mailing list
> Vwdiesel at vwfans.com
> http://www.audifans.com/mailman/listinfo/vwdiesel
>
> 




More information about the Vwdiesel mailing list