[Vwdiesel] No tail lights...

LBaird119 at aol.com LBaird119 at aol.com
Thu Sep 30 23:16:38 PDT 2010


  Ok, Gray/black and gray/red come through the dimmer to the instrument 
lights 
and cigarette lighter light.  They're output.  They're 20ga.   Gray/green 
is also 
output, to block B, #27 then through fuse 7, out block/pin # E9 and C4 as 
gray/black, to tail and parking lighs.
  Input power is a 16ga, red wire from B23.  It pulls 30 power (battery +) 
through the 
relay panel, where it's supplied by a Red, 8 ga through a "P" terminal.
  So, check for power at P, then probe B23 (if your red wire to the switch 
isn't 
showing any potential  ;-)
  Generally your problem is caused by a bad ground and feeding back through 

some other consumer, often a headlight, tail light, etc.  You may be able 
to pull 
other fuses until you kill power to the consumer, then you'll have ground, 
so to 
speak, to your parking, etc, lights.  They'll all go out when you put the 
fuse back 
in because the other side of the consumer will now be powered and can't 
provide 
any sort of ground.
  See if anything comes up and I can figure out where you're pulling a 
ground 
from, they you can usually figure out where the bad ground is.  Most likely 
it's 
the tail lights but could even be a main body ground from the battery.  Try 
stuff 
like the heater fan, wipers and such and see how everything reacts when 
switching on/off with your lights on, then off.
  Too late to think any harder tonight!
    Loren


More information about the Vwdiesel mailing list