sinking clutch pedal

[GLARSH@holonet.net]

ZM>Anyone have an idea which
ZM>one it might be? I am inclined to think its the slave, since I had rebuilt

Zafer...........

This is why we refuse to sell rebuild kits.

If you are losing fluid then it is probably the slave cylinder and there
should be signs of moisture around it. But if there is NO fluid loss
then the seals in the master are not holding.

When seals in slave go bad there is nowhere for the passed fluid to go
except out into the outside world hence the fluid loss and moisture at
the bell housing area. In the master when the seal goes bad the fluid
usually just bleeds back into the reservoir, ergo no loss of fluid.
Same pedal cation in either case.

Hope this helps somewhat????
........Joe
---
 ~ OLX 2.1 TD ~ -       G. Larsh   GAS Inc.   Berzerkeley,CA.          -