Re: Replacing front disks

[barry@olympus.ctron.com (Barry P. Lewis)]

>The manual talks cheerfully about removing a countersunk screw, and then
>taking off the old disks. I have a feeling that the ones on my car aren't
>quite as new and shiny as the ones in the photos, and will probably be
>rusted in place. Has anyone had problems with this before? What was the
>solution?

Be ready to drill out the screw. I can only get them out about half the time.
I have also seen the disks rusted to the hubs. Sometimes you can bang them 
with a hammer and get them loose. On one car, I ended up renting a puller.

And then, sometimes it easy. On my latest car, the countersunk screws were 
not replaced (probably drilled out). Every time I remove the wheel, the disk 
slides around!

Good luck.

Barry