5kS: Brake pad wear sensors

[erict@cta.com (Eric Thorstenson)]

Nothing mind-boggling here, but I discovered last night
that the brake pad wear sensors are wired in series, not
in parallel, as I had assumed. So, if you're trying to
figure out why your brake pad warning light is always on,
check voltage and fix the connection on the drivers side
first, then do the same on the passenger side.

Of course, this is quite evident from the wiring diagram
in Bentley, had I looked there *before* fiddling instead
of after.....

Eric T.   '86 5kS
erict@ra.cta.com