Re: Tooth jummping

[PDQSHIP@aol.com]

That was me a long time ago, and I just did it to my wifes car last nite.
 You can do it without taking the cam belt cover off, but the time is about
the same:

*  remove belt from Hydraulic pump

*  remove upper cam belt cover

*  set flywheel and cam/dist to TDC

*  slide cam belt off cam gear

*  move cam gear one tooth adv  with 19mm wrench on gear(that's counter
clockwise    looking toward the rear of car), keep one hand on belt to
maintain tension and ref one    tooth

*  slide belt back on cam gear

*  large channel locks on dist housing, turn dist to tdc mark 

*  install cam gear cover and HP belt

*  done - 15min total


Hope this helps


Scott
PDQSHIP@aol.com
'87 5ktqRS2 stage VIII, IA stage II
'87 5ktqRS2 stage III