[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

K-jet thanks, trans plugs



Okay, okay....

Thanks to everyone who responded to my question about the idle mix tool. I'll
pick up a long 3mm hex wrench this weekend.

Here's another one: I bought several quarts of the fabled Redline gear oil
this weekend. Imagine my dismay when I discovered that I could not BUDGE
the stupid drain and fill plugs on the transaxle and rear end. They take a 
monster 17mm hex wrench, which I have, but I applied every fiber of my
being in several different contortions to try and loosen them, but no go.
Is there some trick to getting them out? Or am I just a big wuss. And yes,
I'll make sure I can remove the fill plug BEFORE I remove the drain plug.

Aaaaaand I'm still lookin' for a 2/3 worn Dunlop SP8000 size 215/50-15.

Thanks everybody.
-- 
Bryan Gunn                  Email: bgunn@voicetek.com 
Voicetek Corporation          Tel: 508.250.7998
19 Alpha Road                 Fax: 508.250.9378
Chelmsford, MA  01824