Re: Hydraulic clutch question

[PDQSHIP@aol.com]

In a message dated 96-05-09 11:24:00 EDT, you write:

>... at a reasonably high pressure I might add.  It seems as though a seal 
>or valve in the master cylinder is screwed up.  I was wondering if this 
>could possibly be an effect due to air in the lines or if I have to bite 
>the bullet and rebuild/replace the MC.
>
>

Rebuild the MC steve, btdt, same symptoms.....  While you're there, you might
as well rebuild the slave as well (and replace the line betwixt the two),
that brake fluid eats all the paint overspray and cruds up the inside of both
the MC and the slave....   If you want instructions on the rebuild procedure
let me know...

Scott