Re: Coupe q - Turn Signals and anti-roll bars.

[treilley_at_BANKMARK@conseco.com (treilley)]

     I don't think they had that til later in production.  Are you sure it 
     is factory?  Does your Coupe have the stainless header?
     
     Tim NJ 90CQ, 77Spitfire


______________________________ Reply Separator _________________________________
Subject: Coupe q - Turn Signals and anti-roll bars.
Author:  ir000185@pop3.interramp.com at Internet
Date:    7/15/95 6:50 AM


Maintenance time for the Coupe.
     
It must've needed it, for it showed me a -Pay attention to ME sign- on my way 
hom e from work. I was 
sitting at a light with my right turn signal on (or so I thought.) I looked down
and saw no indicator 
flashing. I checked the hazard and they were ok. I checked all the controls on 
th e dash, wipers were out, 
too - Fuse. Or so I thought. I lifted the hood, checked the fuse and it was 
fine.
 I replaced just for GP, but 
it was still no-go.
     
Finally I Put the car in the garage, shut it off and turned it back on again - 
tu rn signals and wipers are 
back. Any Ideas?
     
     
Also, when did Coupes get rear anti-roll bars? Mine, production 8-89, has one. I
just found this out last 
night while inspecting suspension and rotating tires... 
     
Looking at  the bushings all around, all I can say is... Let me know when you 
hav e something available, 
Eric...
     
L8R,
Todd - Akron, Oh
'90 Coupe q
Other lesser beasts...