Fuel Line follow up.. (ref: 89 200q)

[SOP8920@Siena.edu]

Friends,
       Well.. thanks to your excellent advice, the fuel line installation went
well. The line ended up getting a little bent out of shape near the top (front
end), and I had to go in to the shop so they could bend it back. There wasn't
enough leverage with just the front end up on ramps. 
       The lines were easier to install than remove. It was also difficult to
tighten them down. When I brought the car into the shop.. the mechanic bent the
lines back a bit near the rear, so they weren't scrubbing anything. He did the
same for the front. The top two rubber fasteners were difficult to attach.
Other than that... A-OK. 
        Next projects: Replace temp. sending unit and diagnose/repair problem
with washer fluid pump. 

Thanks again everyone. 
                               -Osman Parvez
                                89 200q
                                Siena College
                                Albany NY