Re: CIS Adjusment plug - PN

[ti@bazooka.amb.org (Ti Kan)]

a6561TB@gnn.com writes:
> >I've NEVER seen an Audi with this plug still installed.  In fact, I've
> >never seen one of these plugs, with or without grab wire!
> >
> >It's a good idea though to keep the crud out - I just called the local
> >**** dealer and ordered one.
> 
> Could somebody please tell me what is it you are discussing here?
> What plug? Where is it? What grabber wire?

On K-Jetronic and KE-Jetronic injected cars, there is a hole
on the air-flow meter housing through which you would insert
a CO-adjustment wrench.  It is in the little valley between
the air cone (with large rubber air boot) and the fuel distributor.
On early cars this hole comes plugged from the factory with a
little rubber plug with a metal wire "finger pull ring",  Later
cars have the hole sealed with a flat-topped aluminum plug with no
wire handle, and such plugs are normally damaged upon removal.
The early plug will fit the later cars nicely.

-Ti
96 A4 quattro
84 5000S Turbo
80 4000
-- 
    ///  Ti Kan                Vorsprung durch Technik
   ///   AMB Research Laboratories, Sunnyvale, CA. USA
  ///    Internet: ti@amb.org
 //////  UUCP:     ...!uunet!bazooka!ti
///      URL:      http://sunsite.unc.edu/~cddb/tikan/