Can't bleed the clutch...Please Help.

[baselope@netwide.net (Robert Riley)]

Ok, I just replaced the clutch on my 87 coupe gt.  I changed the pressure 
plate and throw out bearing too.  I made sure that the fork was aligned 
with the slave cylinder piston when the trans was put back up into place. 
 The clutch system had worked before my repair.  Now that the system is 
back together I have tried bleeding the clutch system, but I still can't 
get the slave cylinder to engage.  As far as I can tell, the master 
cylinder is working.  I assume this is true  because when bleeding the 
system and pressing the clutch pedal I get a pressurized stream of fluid 
from the bleeder valve.  One thing to note is that I did let the system 
drian out after disconnecting the hydraulic line.  

Is there some specific procedure I should be using?

the psiton in the slave cyclinder moved freely when the trans was apart.  
Any ideas?

TIA

Justin Riley
aka: baselope@netwide.net  & jr@akamail.com (Permanent e-mail address)

Audi Enthusiast!

"I don't drive FAST,  I FLY low!"