[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

100CSQW tailgate wear



My '92 100CSQ wagon is closing in on 150K and the inevitable tailgate
wear problems are beginning to appear.  Specifically, the molded plastic
interior liner is separating from the two sheet metal screws -- one on
each side, as opposed to the screws atop and under the liner -- that
hold the liner to the tailgate.  The simple, inexpensive solution would
seem to be installing two wide but thin washers behind each side screw
to hold the liner firmly to the tailgate.  Is there a better way to
handle this problem?