Re: 200Q Stumbling

[PDQSHIP@aol.com]

In a message dated 96-11-22 14:22:52 EST, you write:

<< On Monday 11/18 I was on my way home when I tried to accelerate my car
 stumbled at anything above half throttle. As long as I keep the boost at or
 under 1.2bar it runs fine. It wont allow any hard acceleration. It doesn't
 respond to rapid throttle inputs. Feels like I am hitting the rev limiter
 when I floor it. The car is a 1991 200Q 20V. Any help or suggestions would
 be appreciated.
  >>
Bad wires tend to give this symptom on high boost conditions....  A scope
"should" pick it up, but having done a 10vt, the scope didn't catch it, but
the Swap and Try did...  Hard to find an extras set of wires lying around
tho....  Make sure the rotor and cap inside terminals are clean of crud
too....

HTH

Scott