[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: 92S4 vs. 93+S4's...



> Third item: Has anyone ever tried to remove *aftermarket* tinting? Could it
> damage the factory tint in any way when they use a solvent?
> 
... if it is simply a film, I was able to do it on the urQ without using 
much solvent at all.  I found that if you pulled the film off correctly the 
adhesive came with it.  [I wish I could tell you the procedure ... but it 
was ~10 years ago]  I just tried pulling at different rates ... too slow 
and the adhesive stuck to the window.  In any case, the adhesive was not 
unlike rubber cement and I found that by rubbing from the edges toward the 
center of a patch of adhesive I could get most of it off.  I used cigar-
ette lighter fluid to get the rest off, but if I were doing it today I'd 
use "Goo Gone."  I wouldn't worry about damaging the windows or stock 
tinting as long as you don't use something that might scratch the windows.
Be careful of the defrost traces on the rear window ...

HTH & of course YMMV!

Steve Buchholz
s_buchho@kla.com
San Jose, CA (USA)