Re: Radar Detector Installation

[e6941tb@gnn.com]

Edward T Spire wrote:

> I also reported my wiring of a V1 into the overhead panel on the
> UBERWGN (95.5 S6 wagon).  I patched into the hot wire to the light
> switch.  I have had no problems such as those reported above, I can
> operate the sunroof without affecting the detector.  I ran the wire
> through the alignment hole for the tiny center visor and out from under
> theat visor's mounting plate, and I suction cup'd the detector to the
> window above the rear view mirror.  Works very well, has a very high
> placement (i.e., good horizon), can see out the back just fine (the V1
> has front and back antenna) and is almost invisible from outside.

Same here, only I used the visor clamp, that came with my V1.
*Due to it's high mounting point it has recently revealed a_sure_trap
from some 2.5mi(!) away on the PA turnpike, when I was returning to
Philly from a Harrisbourg Mid Atlantic QClub session.
*Due to it's high mounting point_behind_the green windshield strip my
faithfull V1 has not been stolen yet.

Igor Kessel
'89 200TQ