10mm triple square

["R. Cummings" <cumm@flash.net>]

I found 8 and 10mm triple square tools at Pep Boys, my local parts house and
the place in town that specializes in redoing heads when the water pump
fails, the timing belt jumps off and the pistons bend the valves (like mine
did).

BTW, when I rebuilt the CV joints, the boots were leaking and I had to dig
the crud out of the drive shaft cap screws before tapping the tool into the
head with a little hammer (or the end of the ratchet - naughty naughty).
Failure to do this can result in a screwed up tool or worse yet round
splines in the cap screw.

Bob Cummings
87 GT Coupe