Re: Sunroof parts needed

[Raudi83TQ@aol.com]

No big trick to felt seal. It comes longer than needed. Note where the ends
meet, trailing edge, middle normal. Pull off old seal, clean panel edge.
Center new seal along front edge and press on carefully starting at center
and work to corner. Pulling off to start again is not a good idea so go
slowly, it is a press fit. at corners work seal on bending it as you go, it
is flexible. When you get to the back center, cut off extra material with a
saw or dremel. You can use a cutter but you will need to spread the metal
inside the seal after cutting. Be careful to have the ends meet tightly but
not overlaping. It is easier than this sounds! 

John
83urq