[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: Extrude hone



On Wed, 2 Apr 1997, Mann Law wrote:

> 	Now, for the $10 question:  The plug between the air flow 
> metering flap and fuel distirbutor---anyone drill this plug and play with 
> what is underneath?  Results?
Bruce,

	Are you talking about the one that requires a 3mm allen wrench 
just forward of the boot over the airflow meter flap?   If so, then I 
have twiddled with this to achieve a better mixture.   It sure affects 
how the engine runs.   Try it with a duty cycle meter hooked up to the 
2-wire connector behind the fuel metering distributor and go for 42%.   
Use the engine ground instead of the ground in the connector though.

Later,
Graydon D. Stuckey 
'86 5KCSTQ, GDSstageIII
"No, its our family car."