Re: Ignition Wire Loom

[Andrew Duane USG/PE <duane@zk3.dec.com>]

Hairy green toads from Mars made Mark Pollan say:

> Trivial stuff in the grand scheme but...
> 
> I got new ignition wires from Linda but they are not threaded through
> a loom.  What is the best/easiest way to get them into the existing loom.
> 
> Should I cut the loom down the seam and pry it open a bit to get the
> new wires in?  Glue it back together?  Super Glue or Epoxy?

BTDT.

If it's the same loom as in my '89 100Q, it snaps off the engine,
then unsnaps down the side, opening it right up to put the wires
in place. Total time: <3 minutes.

-- 

Andrew L. Duane (JOT-7)			duane@zk3.dec.com
Digital Equipment Corporation		(603)-881-1294
110 Spit Brook Road
M/S ZKO3-3/U14
Nashua, NH    03062-2698

Only my cat shares my opinions, and she's too heavy to care.