RE: G60 dual piston urq conversion

[John Karasaki <johkar@teleport.com>]

At 11:11 AM 11/5/97 -0500, you wrote:
>John where did you get your calipers??  Your cost is significantly lower
>than what I have been quoted for dual piston Girling G-60 Calipers.
>Also you did not need rotors??  You must have had 276mm rotors to
>start?? I am thinking of the same conversion for my 1990 90 20 Valve
>Quattro.
>
Doug,

I got them at a wrecking yard here in Portland.  You need new rotors too.  I
got those from Halsey Import Autoparts for about $40 each.  Very reasonable
cost for a great upgrade!  BTW, you need the 5kt rotors.  The URQ rotors
will NOT work!

Regards,


John Karasaki

J & L Enterprises
"Our Future is Built by Hard Work"