[Author Prev][Author Next][Thread Prev][Thread Next][Author Index][Thread Index]

Re: PS pump-banjo seals?

To: Myke456 <Myke456@aol.com>
Subject: Re: PS pump-banjo seals?
From: four.rings@mcione.com
Date: Fri, 19 Dec 1997 23:54:55 -0500
Cc: quattro@coimbra.ans.net
References: <19aa9b3c.349b14ca@aol.com>
Sender: owner-quattro@coimbra.ans.net

Myke456 wrote:
> 
> I'm about to replace my PS pump for the 1st time. I'd like to have everything
> I need before starting...Bentley shows a "ring/seal" under the banjo fittings. Is this metal or rubber, and does it get replaced or used over?

Cu or Al on your car. Viton rubber on '89->  100/200. Not
interchangeable.
Replace them, they cost pennies. The sys develops 1800-2000psi.

-- 
Igor Kessel
'89 200TQ -- 18psi (TAP)
'98 A4TQ -- on an 18-wheeler
Philadelphia, PA
USA

References:
- PS pump-banjo seals?
  - From: Myke456 <Myke456@aol.com>

Prev by Author: Re: A8 wheels vs A6/A4
Next by Author: Re: HKS Sequential Bypass Valve - Report
Prev by thread: PS pump-banjo seals?
Next by thread: Re: PS pump-banjo seals?
Index(es):
- Author
- Thread