RE: Replacing rotors on '93 90CS

["Perry, Christopher" <cperry@cotl.com>]

My apologies, I was thinking of the wife's Passat wagon.
chris perry

>-----Original Message-----
>From:	Chris Newbold [SMTP:cnewbold@transarc.com]
>Sent:	Thursday, January 08, 1998 8:07 AM
>To:	Perry, Christopher
>Cc:	'Elliott Potter'; 'Quattro List'
>Subject:	RE: Replacing rotors on '93 90CS
>
>At 05:38 PM 1/7/98 , Perry, Christopher wrote:
>>The rear do require you to remove the axle nut but it is relatively easy
>> - not torqued as much as the front.  You will remove the nut, a washer,
>>the outer wheel bearing then the rotor.  If you are replacing the rotor
>>you will need to either press the race and bearing out of the old hub
>>and into the new one or buy new races and bearings and press them into
>>the new hub. Dealing with the parking break cable will be the major PITA
>>for this job.
>
>Nope. The rears on the 93s are just like the front. They have a hub,
>which holds the bearing, and the rotor just fits over the top.
>
>Makes things a lot simpler!
>
>-Chris
>1993 90CS 63k