|
I've got the Zelenda catalog before me, set to order a passel
of special tools as per Mssr. Bentley's instructions. According to
archived discussions, one might expect to get away without many of these, but in
some cases not without a fair amount of anguish. I'd sure appreciate
opinions on the relative merit/cost-benefit/pain factor relating to using
substitutes or not for each of the following. The project is a 3B 20V
turbo engine.
Removal of vibration
damper
counter
holder 2084
All I need, right,
remembering the thread about 3ft extensions and 110lb
wives.
Idler pulley removal
puller
3034
installer
use the icebox to chill new pulley...
Crank oil seal, rear
press in sleeve
2003/1
removal
tool 2086
Crank oil seal, front
removal
tool 3203
install
2080A
Rear pilot
bearing
removal
extracter, no number
install
VW 432, basically a 50mm arbor, but tres cher anyway
Thanks,
Brandon Hull
'91 CQ
|